Iskalni niz:
išči po
išči po
išči po
išči po
Vrsta gradiva:
Jezik:
Št. zadetkov: 4
Impact of various rpm levels on rotary and pendulum spreaders performance
Bogomir Muršec, Anton Ploj
Izvirni znanstveni članek
Oznake: rotary spreader;pendulum spreader;spread width;spread flow;
The paper demonstrates how different levels of shaft revolutions affect the performance of mono-disk rotary and pendulum fertiliser widely used by Slovenian farmers. Tests have been conducted on mono-disk rotary spreader manufactured by the Italian company AGREX, and on a pendulum spreader manufactu ...
Leto: 2002 Vir: Fakulteta za kmetijstvo in biosistemske vede (UM FKBV)
Novo biorazgradljivo splošno traktorsko transmisijsko olje na osnovi oljne repice
Anton Ploj, Boris Kržan, Janez Bedenk, Marta Feldin
Izvirni znanstveni članek
Oznake: olja;biorazgradljiva olja;repična olja;
V Sloveniji je trenutno okrog 160 000 traktorjev. Za delovanje prenosnega sistema posameznega traktorja je potrebno od 30 do 100 litrov mazalnega olja, zamenjava olja pa se ponavadi opravi enkrat na leto.
Leto: 2000 Vir: Fakulteta za kmetijstvo in biosistemske vede (UM FKBV)
ǂA ǂgeneralized neural network model of ball-end milling force system
Uroš Župerl, Franc Čuš, Bogomir Muršec, Anton Ploj
Izvirni znanstveni članek
Oznake: čelno frezanje;rezalne sile;rezalni parametri;modeliranje;posplošena envronska omrežja;end-milling;cutting forces;cutting parameters;generalized neural networks;modeling;
The focus of this paper is to develop a reliable method to predict 3D cutting forces during ball-end milling process. This paper uses the artificial neural networks (ANNs) approach to evolve an generalized model for prediction of cutting forces, based on a set of input cutting conditions. A set of t ...
Leto: 2005 Vir: Fakulteta za strojništvo (UM FS)
ǂA ǂHybrid analytical-neural network approach to the determination of optimal cutting conditions
Uroš Župerl, Franc Čuš, Bogomir Muršec, Anton Ploj
Izvirni znanstveni članek
Oznake: optimization;cutting conditions;turning;analytical-neural routine;database;
In the contribution, a new hybrid optimization technique for complex optimization of cutting parameters is proposed. The developed approach is based on the maximum production rate criterion and incorporates 10 technological constrains. It describes the multi-objective techniqueof optimization of cut ...
Leto: 2004 Vir: Fakulteta za strojništvo (UM FS)
Št. zadetkov: 4
Ključne besede:
Leto izdaje:
Avtorji:
Repozitorij:
Tipologija:
Jezik: