Snovanje orodja za tlačno litje

diplomsko delo

Tea Andrejčič (Author), Stanislav Pehan (Mentor)

Abstract

V diplomskem delu je prikazan postopek snovanja orodja za tlačno litje. Predstavljeno je določanje parametrov in preračuni za polnitev puše ter širino odzračevalnih kanalov. Model orodja se izdeluje v programu Creo 2.0. Predstavljene so tudi simulacije dveh različic stiska v programu MAGMASOFT, s pomočjo katerih so bile predhodno videne težave pri zalitosti odlitka. Te so bile po prikazu simulacij in na podlagi izkušenj konstrukterjev odpravljene, tako da so po fizični izdelavi orodja pri litju dobili odlitke v skladu s kupčevimi zahtevami.

Keywords

tlačno litje;orodje za tlačno litje;orodjarstvo;aluminijeve zlitine;snovanje;diplomske naloge;

Data

Language:	Slovenian
Year of publishing:	2017
Typology:	2.11 - Undergraduate Thesis
Organization:	UM FS - Faculty of Mechanical Engineering
Publisher:	[T. Andrejčič]
UDC:	621.74.07-11(043.2)
COBISS:	21138966
Views:	2175
Downloads:	53
Average score:	0 (0 votes)
Metadata:

Other data

Secondary language:	English
Secondary title:	Die casting tool design
Secondary abstract:	This diploma thesis shows the procedure of making tools for die casting. It presents setting of parameters, calculations for shot sleeve filling and for the width of the ventilation sealing section. The tool model is made in Creo 2.0. The thesis also presents the simulations of two different casts in MAGMASOFT, which previously helped uncover problems with cast roundness. These problems were dealt with after the display of simulations and on the basis of experienced constructors, so that the buyers got what they requested when the tools were physically made.
Secondary keywords:	die casting;die casting tool;toolmaking;design;casting;aluminium alloys;
URN:	URN:SI:UM:
Type (COBISS):	Bachelor thesis/paper
Thesis comment:	Univ. v Mariboru, Fak. za strojništvo, Konstrukterstvo
Pages:	X, 35 f.
ID:	10863464