zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
Urban Kranjc (Author), Franci Pušavec (Mentor)

Abstract

Glavni vzrok za preveliko obrabo, slabo kakovost površin izvrtin ter predčasen lom orodja pri konvencionalnem vrtanju predstavlja neučinkovito hlajenje in mazanje rezalne cone. Tako zaključno delo obravnava metodo visokotlačnega dovajanja hladilno mazalne emulzije skozi orodje in ga glede na obrabo orodja ter velikost odrezkov primerja s konvencionalnim nizkotlačnim dovodom. Ugotovili smo, da je za uporabljeno orodje (Sumitomo Electric) razlika med obrabama pri konvencionalnem in visokotlačnem dovajanju skozi orodje zanemarljivo majhna. Po drugi strani pa smo ugotovili, da se močno izboljša tvorba in lomljivost odrezkov pri visokotlačnem vrtanju, kar vodi do večje stabilnosti in produktivnosti procesa.

Keywords

diplomske naloge;visokotlačno hlajenje;konvencionalno hlajenje;hlajenje skozi sveder;vrtanje;obraba orodij;tvorba odrezkov;hardox 400;

Data

Language: Slovenian
Year of publishing:
Typology: 2.11 - Undergraduate Thesis
Organization: UL FS - Faculty of Mechanical Engineering
Publisher: [U. Kranjc]
UDC: 621.564.3:621.95(043.2)
COBISS: 25377795 Link will open in a new window
Views: 593
Downloads: 158
Average score: 0 (0 votes)
Metadata: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Other data

Secondary language: English
Secondary title: Through-tool high pressure coolant drilling
Secondary abstract: The main cause of excessive wear, poor surface finish of drill holes and premature tool breakage with conventional drilling is inefficient cooling and lubrication of the cutting zone. This paper represents through % tool high pressure coolant application in drilling and compares it with conventional low pressure cooling using tool wear and chip length. The results illustrated that the difference between tool wear of conventional and tool wear of high pressure cooling was negligibly small. The results also showed that chip breakage was more efficient under HPC method and since there was no formation of continuous chips, stability and productivity of the drilling process were improved.
Secondary keywords: thesis;high pressure cooling (HPC);conventional cooling;through-tool cooling;drilling;tool wear;chip formation;
Type (COBISS): Final paper
Study programme: 0
Embargo end date (OpenAIRE): 1970-01-01
Thesis comment: Univ. v Ljubljani, Fak. za strojništvo
Pages: XV, 36 f.
ID: 11955965
Recommended works:
, zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
, magistrsko delo magistrskega študijskega programa II. stopnje Strojništvo
, zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
, magistrsko delo magistrskega študijskega programa II. stopnje Strojništvo