Primož Žibret (Author), Gregor Bobovnik (Author), Jože Kutin (Author)

Abstract

The volumetric primary standard with a constant volume (pVTt) determines the flow rate from the rate of change of gas density in the defined measuring volume. The key element of the measuring system that uses the flying start–stop method is a diverter. This paper presents a time correction model that adapts the correction according to the diverting speed implemented in our pVTt system developed for flow rates smaller than 12 mg min$^{−1}$ . A detailed study of the diverter’s effects on the effective collection time and two methods for determining the time correction are presented. One is based on the ISO 4185 standard and the other on measurements of the dynamic pressure upstream of the diverter. A set of correction time measurements were made at different diversion speeds to define the correction model at a flow rate of 9 mg min$^{−1}$ . The results show very good agreement between the measurements with both methods and the defined correction model. Additional measurements were made at smaller flow rates and the results indicate the independence of the time correction from the measured flow rate.

Keywords

merjenje pretoka;časovna korekcija;preklopni element;flow rate measurement;time correction;diverter;

Data

Language: English
Year of publishing:
Typology: 1.01 - Original Scientific Article
Organization: UL FS - Faculty of Mechanical Engineering
UDC: 532.57:681.586
COBISS: 109539075 Link will open in a new window
ISSN: 1424-8220
Views: 190
Downloads: 62
Average score: 0 (0 votes)
Metadata: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Other data

Secondary language: Slovenian
Secondary keywords: merjenje pretoka;časovna korekcija;preklopni element;
Type (COBISS): Article
Pages: str. 1-12
Volume: ǂVol. ǂ22
Issue: ǂiss. ǂ11
Chronology: May 2022
DOI: 10.3390/s22114001
ID: 15468522
Recommended works:
, zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
, magistrsko delo magistrskega študijskega programa II. stopnje Strojništvo
, zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo