Vpliv tehnoloških parametrov procesa globokega vleka na najmanjšo debelino okroglega izdelka

diplomsko delo Visokošolskega strokovnega študijskega programa I. stopnje Strojništvo - Projektno aplikativni program

Žiga Hribar (Author), Tomaž Pepelnjak (Mentor)

Abstract

Pri postopku globokega vleka pride do tanjšanja stene izdelka. Ker na to vpliva več dejavnikov, smo na začetku diplomskega dela raziskali preoblikovanje pločevine in globoki vlek. Globoki vlek je temelj tega diplomskega dela, zato smo podrobno opisali postopek in parametre. Na podlagi tega smo določili tri glavne parametre, s katerimi smo izvedli eksperiment. Za načrtovanje eksperimentov smo uporabili Taguchijevo metodo. Eksperiment smo izvedli na hidravlični stiskalnici. Za merjenje debeline stene smo najprej raziskali načine in metode merjenja. Na podlagi tega smo izbrali metodo, s katero smo izmerili najmanjšo debelino stene lončka. Na koncu diplomskega dela smo analizirali rezultate, izračunali merilno negotovost in z uporabo programa dobili enačbo, ki predstavlja vpliv začetnih parametrov. S programom smo ugotovili, da imajo izbrani začetni parametri pomemben vpliv na debelino stene izdelka.

Keywords

diplomske naloge;preoblikovanje pločevine;globoki vlek;vpliv parametrov na globoki vlek;metode merjenja;načrt eksperimentov;vrednotenje rezultatov;

Data

Language:	Slovenian
Year of publishing:	2023
Typology:	2.11 - Undergraduate Thesis
Organization:	UL FS - Faculty of Mechanical Engineering
Publisher:	[Ž. Hribar]
UDC:	621.983.3:531.7(043.2)
COBISS:	157075715
Views:	109
Downloads:	45
Average score:	0 (0 votes)
Metadata:

Other data

Secondary language:	English
Secondary title:	Influence of the technological parameters of the deep drawing process on the minimum thickness of a round product
Secondary abstract:	In the deep drawing process, the wall of the product becomes thinner. Since this is influenced by several factors, at the beginning of the thesis we investigated sheet metal forming and deep drawing. Deep drawing is the foundation of this thesis, so we have described the process and parameters in detail. Based on this, we determined three main parameters with which we conducted the experiment. The Taguchi method was used to design the experiments. The experiment was carried out on a hydraulic press. To measure the thickness of the wall, we first investigated the ways and methods of measurement. Based on this, we chose the method with which we measured the minimum thickness of the wall of the pot. At the end of the thesis, we analyzed the results, calculated the measurement uncertainty and using the program obtained an equation representing the influence of the initial parameters. With the program, we found that the selected parameters have a significant impact on the wall thickness of the product.
Secondary keywords:	sheet metal forming;deep drawing;influence of parameters;measurement methods;plan of experiments;evaluation of results;
Type (COBISS):	Bachelor thesis/paper
Study programme:	0
Embargo end date (OpenAIRE):	1970-01-01
Thesis comment:	Univ. v Ljubljani, Fak. za strojništvo
Pages:	XX, 52 str.
ID:	19384791