Stroj za razširjanje tankostenskih cevi

magistrsko delo

Denis Krajnc (Author), Ivo Pahole (Mentor), Aleš Hace (Mentor), Karl Gotlih (Co-mentor)

Abstract

Namen je bil izdelati stroj za razširjanje tankostenskih cevi na enem koncu po upogibanju. Te cevi so poljubnih dolžin od 1,5 metra do največ 6 metrov. Premeri cevi znašajo 80 mm, 100 mm in 125 mm. Cevi se izdelujejo iz pločevine. Časovni obseg razširjanja ene cevi se spreminja sorazmerno z dolžino cevi. Pri montaži oziroma spajanju cevi, je potrebno na enem koncu cev razširiti, tako da je možna montaža brez orodja. Testirali smo sile med obdelovalnim postopkom razširjanja in izbrali pravo orodje. S programskim orodjem Solidworks smo izdelali model stroja za razširjanje tankostenskih cevi, za katerega smo zapisali tudi program v uporabniškem vmesniku STEP 7 micro/WIN in ga testirali ter predstavili rezultate. Izbrali smo tudi najprimernejše komponente stroja ter jih podrobneje opisali.

Keywords

razširjanje;tankostenske cevi;modeliranje;posebni postopki obdelave;pločevine;orodje za razširjane;mehatronski sistemi;magistrske naloge;

Data

Language:	Slovenian
Year of publishing:	2013
Typology:	2.09 - Master's Thesis
Organization:	UM FS - Faculty of Mechanical Engineering
Publisher:	[D. Krajnc]
UDC:	681.52:621.774.7(043.2)
COBISS:	17602070
Views:	1636
Downloads:	136
Average score:	0 (0 votes)
Metadata:

Other data

Secondary language:	English
Secondary title:	Machine for the extension of thin-walled tubes
Secondary abstract:	The purpose was to form a machine for extending thin-walled tubes at one end, after bending. These tubes are of optional lengths from 1.5 to a maximum of 6 metres. The diameters are 80, 100, and 152 milimetres in length. The tubes are made of sheet metal. The time dimension when extending each tube changes in proportion to the tube's length. When fitting or joining the tubes, it is necessary to extend the tube at one end, so that it is possible to set it up without any tools. We tested the forces between the handling procedures when extending, and thus chose the correct tool. Using the programming tool," Solidworks" we manufactured a model of the machine for the extensions of thin-walled tubes, for which we wrote a program within the user interface STEP 7 micro/WIN, tested it, and presented the results. We then chose the more appropriate components of the machine, and fully described them.
Secondary keywords:	extension;thin-walled tubes;modeling;special processing of steel;steel;tool for extension;mechatronic system;
URN:	URN:SI:UM:
Type (COBISS):	Master's thesis/paper
Thesis comment:	Univ. v Mariboru, Fak. za strojništvo, Mehatronika
Pages:	VII, 46 f., [6] f., 16 f.
ID:	8727222