Digitalizacija in izdelava 3D-modela figure

diplomsko delo

Miha Gotlih (Author), Vojko Pogačar (Mentor), Igor Drstvenšek (Co-mentor)

Abstract

Diplomsko delo obravnava problematiko izdelave digitalnega 3D-modela figure, pri čemer uporabimo kot vhodni podatek 2D-sliko figure samo v enem pogledu. Z obzirom na prepoznavnost figure izdelamo 3D-model, ga dodelamo po željah stranke in pripravimo za izdelavo. Sledi izbira primerne izdelovalne tehnologije in izdelava fizičnega 3D-modela. Najpogosteje uporabimo komparativno metodo in tako sproti popravljamo in dodelujemo figure. Ugotovimo, da je za takšne izzive potrebne veliko prakse in poznavanja različnih programskih oprem.

Keywords

digitalizacija;3D-model;modeliranje;konstruiranje;selektivno lasersko sintranje;diplomske naloge;

Data

Language:	Slovenian
Year of publishing:	2016
Typology:	2.11 - Undergraduate Thesis
Organization:	UM FS - Faculty of Mechanical Engineering
Publisher:	[M. Gotlih]
UDC:	004.925.8:621.762.5(043.2)
COBISS:	19520534
Views:	1129
Downloads:	115
Average score:	0 (0 votes)
Metadata:

Other data

Secondary language:	English
Secondary title:	Digitalisation and creating a 3D model of a figure
Secondary abstract:	The diploma thesis deals with the issue of making a digital 3D model of a figure, using as input only a 2D image in one view. With care to the recognition of the figure we produce the digital 3D model and later adjust it to every additional customer's wishes and prepare it for manufacturing. A selection of an appropriate manufacturing technology and making a physical 3D model follows. Most commonly the comparative method is used so the figures are promptly corrected and adjusted. We find out that for such challenges a lot of practice and knowledge of various software is required.
Secondary keywords:	digitalization;3D model;modelling;design;selective laser sintering;
URN:	URN:SI:UM:
Type (COBISS):	Undergraduate thesis
Thesis comment:	Univ. v Mariboru, Fak. za strojništvo
Pages:	IX, 42 f.
ID:	9115217