Analogue experimental study of fiber formation on two-wheel spinner
Povzetek
In this paper, the process of mineral fiber formation was investigated experimentally on a two-wheel spinner by means of high-speed imaging. Analogue isomalt melt was fiberized at different rotational speeds of spinner wheels, melt flow rates and impingement positions so that the fiberization process was dynamically similar to an industrial mineral wool production process. Images of fiber formation and transport reveal highly complex dynamics of these processes, as fibers mostly occur in form of 3D mutually intertwined structures such as clusters, strands and veils periodically shedding from the melt film. Despite the complexity of flow structures, there is a clear trend of increasing mean fiber length and expansion angle of the coaxial fiber-laden flow as the Weber number and the ratio of melt film velocity to blowing air velocity are increased. The fiberization efficiency (ratio of fiber mass deposited on the collecting mesh to the mass of melt poured) is affected by the impingement position and flow rate of melt as well as the Weber number of melt film. The optimum efficiency was attained at 30° (1 o'clock) impingement position and the ratio of melt film to blowing air flow velocity close to unity.
Ključne besede
spinners;fiber formation;mineral wool;multiphase flow;primary layer;high-speed imaging;
Podatki
| Jezik: | Angleški jezik |
|---|---|
| Leto izida: | 2020 |
| Tipologija: | 1.01 - Izvirni znanstveni članek |
| Organizacija: | UL FS - Fakulteta za strojništvo |
| UDK: | 519.8:621.928.3(045) |
| COBISS: |
16312323
|
| ISSN: | 0039-2480 |
| Matična publikacija: | Strojniški vestnik |
| Št. ogledov: | 510 |
| Št. prenosov: | 455 |
| Ocena: | 0 (0 glasov) |
| Metapodatki: |
|
Ostali podatki
| Sekundarni jezik: | Slovenski jezik |
|---|---|
| Sekundarni naslov: | Analogna eksperimentalna študija tvorbe vlaken na dvokolesni centrifugi |
| Sekundarne ključne besede: | centrifuge;razvlaknjenje;mineralna volna;večfazni tok;primarna plast;hitre kamere; |
| Strani: | str. 279-288, SI 37 |
| Letnik: | ǂVol. ǂ66 |
| Zvezek: | ǂno. ǂ5 |
| Čas izdaje: | May 2020 |
| DOI: | 10.5545/sv-jme.2020.6557 |
| ID: | 11724491 |
Priporočena dela:
Analogue experimental study of fiber formation on two-wheel spinner
2020,
ni podatka o podnaslovu
Kinematika toka vlaknaste strukture kamene volne v zračnem toku odpiha
2018,
doktorsko delo
Model razvlaknjenja taline na dvokolesni centrifugi
2019,
zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
Analiza nihanj prsta z uporabo hitre kamere
2017,
ni podatka o podnaslovu
Modalno posodabljanje s pomočjo hitre kamere
2017,
magistrsko delo magistrskega študijskega programa II. stopnje Strojništvo