Fusing optical coherence tomography and photodiodes for diagnosis of weld features during remote laser welding of copper-to-aluminum
Povzetek
This study has been designed to investigate whether variations in the features of laser weldments can be isolated and diagnosed by fusing photodiodes and optical coherence tomography (OCT). Two manufacturing scenarios (variation in laser power and focal offset) have been considered during remote laser welding of 0.2 mm thick Cu foils on 2 mm thick Al 1050 plates with an adjustable ring mode laser integrated with a 1D oscillation head. The process was monitored by measuring weld penetration depth with OCT and by process emissions (plasma and back-reflection) via photodiodes. The acquisition frequency of all signals was 40 kHz. Strong correlations (r > 0.75) were shown between plasma, back-reflection, and OCT signals and measured depth and width of the weld. Weak correlations (r < 0.5) between voids, cracks, and sensor signals were observed. Although plasma is the predominant signal that carries most of the information about the process, and the OCT allows direct measurement of the penetration depth, their integration reached 87% classification accuracy of the tested welding scenarios. The main misclassification was observed between “good weld” and “over weld,” defined by the measured weld depth. Sensor fusion strategies with manufacturing implications are discussed throughout the paper.
Ključne besede
lasersko varjenje;nadzor procesa;OCT;fotodetektorji;laser welding;process monitoring;photodetectors;
Podatki
| Jezik: | Angleški jezik |
|---|---|
| Leto izida: | 2023 |
| Tipologija: | 1.01 - Izvirni znanstveni članek |
| Organizacija: | UL FS - Fakulteta za strojništvo |
| UDK: | 621.791 |
| COBISS: |
138309123
|
| ISSN: | 1042-346X |
| Št. ogledov: | 865 |
| Št. prenosov: | 249 |
| Ocena: | 0 (0 glasov) |
| Metapodatki: |
|
Ostali podatki
| Sekundarni jezik: | Slovenski jezik |
|---|---|
| Sekundarne ključne besede: | lasersko varjenje;nadzor procesa;OCT;fotodetektorji; |
| Vrsta dela (COBISS): | Članek v reviji |
| Strani: | str. 1-10 |
| Zvezek: | ǂVol. ǂ35 |
| Čas izdaje: | 2023 |
| DOI: | 10.2351/7.0000803 |
| ID: | 17754893 |
Priporočena dela:
Fusing optical coherence tomography and photodiodes for diagnosis of weld features during remote laser welding of copper-to-aluminum
2023,
ni podatka o podnaslovu
Penetration-depth control in a remote laser-welding system based on an optical triangulation loop
2021,
ni podatka o podnaslovu
Lasersko daljinsko varjenje z adaptivnim sledenjem zvarnemu robu
2018,
diplomska naloga visokošolskega strokovnega študijskega programa I. stopnje strojništvo
Remote laser welding with in-line adaptive 3D seam tracking
2019,
ni podatka o podnaslovu
Power control during remote laser welding using a convolutional neural network
2020,
ni podatka o podnaslovu