Dominika Gornik Bučar (Author), Miran Merhar (Author), Bojan Gospodarič (Author)

Abstract

The geometry of a drilling tool largely affects the quality of the newly formed surface. When drilling through a composite panel, the hole edge quality on the outlet side is significantly worse than on the inlet side, so the choice of the appropriate tool geometry is crucial. Even if the tool geometry is correct, tool wear also has a strong influence on the quality of the newly formed surface of the holes. With the tool wear, the force in the direction of drilling and torque around the axis of drilling are increasing which can affect to the delamination of particle board on the outlet side. The proposed model for hole edge quality prediction on the outlet side was tested on an experimental model where the cutting forces and torque in the drilling direction were measured, and the quality of the newly formed surfaces was evaluated every 180 holes using a visual method.

Keywords

vrtanje;rezalne sile;vlaknena plošča;površina;delaminacija;

Data

Language: English
Year of publishing:
Typology: 1.08 - Published Scientific Conference Contribution
Organization: UL BF - Biotechnical Faculty
UDC: 621.9
COBISS: 2151817 Link will open in a new window
Views: 909
Downloads: 347
Average score: 0 (0 votes)
Metadata: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Other data

Secondary language: Unknown
Secondary keywords: drilling;cutting forces;particle board;surface;delamination;quality of the edge;
File type: application/pdf
Type (COBISS): Not categorized
Pages: Str. 29-33
ID: 9077828