Sebastjan Žagar (Avtor), Boštjan Markoli (Avtor), Iztok Naglič (Avtor), Roman Šturm (Avtor)

Povzetek

The present study investigates the effect of shot peening (SP) on the mechanical properties and surface roughness of 7075 aluminum alloy during different stages and conditions of heat treatment. The mechanical properties were determined by measuring Vickers microhardness profiles and residual stress profiles, while the amount of alloying elements present in the solid solution of the samples under different heat treatment conditions was determined by measuring the electrical conductivity. The results show that the increase in microhardness near the SP surface and the maximum compressive residual stresses are mainly related to the content of alloying elements in the solid solution. Surface roughness increases with increasing SP Almen intensity, and samples with the highest microhardness and residual stresses have the lowest surface roughness.

Ključne besede

aluminijeva zlitina 7075;udarno utrjevanje;mikrotrdota;zaostale napetosti;površinska hrapavost;aluminum alloy 7075;shot peening;microhardness;residual stresses;surface roughness;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UL FS - Fakulteta za strojništvo
UDK: 620.1:669.715(045)
COBISS: 62013443 Povezava se bo odprla v novem oknu
ISSN: 1996-1944
Št. ogledov: 385
Št. prenosov: 119
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Slovenski jezik
Sekundarne ključne besede: aluminijeva zlitina 7075;udarno utrjevanje;mikrotrdota;zaostale napetosti;površinska hrapavost;
Vrsta dela (COBISS): Članek v reviji
Strani: str. 1-11
Letnik: ǂVol. ǂ14
Zvezek: ǂiss. ǂ9
Čas izdaje: May 2021
DOI: 10.3390/ma14092220
ID: 12863800
Priporočena dela:
, zaključna naloga univerzitetnega študijskega programa I. stopnje Strojništvo
, diplomsko delo Visokošolskega strokovnega študijskega programa I. stopnje Strojništvo