Rapid prototyping processes give new possibilities to numerical copying techniques

Ivo Pahole (Avtor), Igor Drstvenšek (Avtor), Mirko Ficko (Avtor), Jože Balič (Avtor)

Povzetek

Due to the appearance of numerically controlled machine tools the conventional copying from physical model has almost lost its importance. Instead, the model of numerical copying is widely used. Until recently, geometry could be copied predominantly in the touching manner and the manufacture of copied - measured shapes on CNC machine tools mainly did not pose o problem. However, because of the introduction of optical copying of geometrical data it is possible to copy the shapes which, sometimes, cannot be made by conventional machining processes (small radii of curvature, negative angles, etc.). The paper describes how these problems can be solved with layered technology processes within a very short time.

Ključne besede

proizvodne tehnologije;izdelava prototipov;numerično kopiranje;CAD/CAM;digitalizacija;manufacturing technologies;prototype generation;rapid prototyping;numerical copying;CAD/CAm;digitalization;

Podatki

Jezik:	Angleški jezik
Leto izida:	2005
Tipologija:	1.01 - Izvirni znanstveni članek
Organizacija:	UM FS - Fakulteta za strojništvo
UDK:	621.7.07:004.8
COBISS:	9630230
ISSN:	0924-0136
Št. ogledov:	1329
Št. prenosov:	85
Ocena:	0 (0 glasov)
Metapodatki:

Ostali podatki

Sekundarni jezik:	Angleški jezik
Sekundarne ključne besede:	proizvodne tehnologije;izdelava prototipov;numerično kopiranje;CAD/CAM;digitalizacija;
URN:	URN:SI:UM:
Strani:	str. 1416-1422
Letnik:	ǂVol. ǂ164-165
Čas izdaje:	15 May 2005
ID:	8718297