diplomsko delo
Tomislav Kovač (Avtor), Stanislav Pehan (Mentor)

Povzetek

V diplomski nalogi sem opisal postopek koncipiranja merilne priprave ohišja avtomobilske luči. V začetku naloge sta predstavljena problem in cilj naloge, ki opisuje koncipiranje in snovanje merilne priprave za testiranje geometrijskih karakteristik prednjih avtomobilskih luči. Zastavljeni so bili konkretni cilji, zahtevekvnik pa je bil sestavljen in definiran detajlno. Pri snovanju je bil poudarek na treh točkah. Prva točka je velikost avtomobilske luči, in sicer težava pri namestitvi ohišja avtomobilske luči na osnovno ploščo. Druga točka predstavlja vpenjanje avtomobilske luči na merilno pripravo, in tretja točka namestitev nosilcev merilne ure. Zasnova je sledila načelu robustnega snovanja. Merilna priprava je na koncu izdelana v ozkem tolerančnem območju in mora zagotoviti ponovljivost meritev.

Ključne besede

merilna priprava;avtomobilska luč;ročna vpenjala;diplomske naloge;

Podatki

Jezik: Slovenski jezik
Leto izida:
Tipologija: 2.11 - Diplomsko delo
Organizacija: UM FS - Fakulteta za strojništvo
Založnik: [T. Kovač]
UDK: 53.084:621.7.08(043.2)
COBISS: 19556374 Povezava se bo odprla v novem oknu
Št. ogledov: 1129
Št. prenosov: 137
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Angleški jezik
Sekundarni naslov: Conceiving and design of measuring device of automotive headlight housing
Sekundarni povzetek: The aim of this diploma paper was to describe the process of conceiving and designing of measuring device for testing geometric characteristics of automotive light housing. At the beginning the problem and the aim of diploma paper are presented. Concrete objectives have been established, and the specification was structured and defined in detail. When designing the measuring device there were three important points to be considered. The first one was the light size presenting a problem when installing the automotive light housing on base plate. Clamping the light onto measuring device and installing brackets of measuring device were the other two important points. The design was based on the principle of robust designing. Finally, the measuring device is designed in a small range of tolerance and needs to ensure repeatability.
Sekundarne ključne besede: measuring device;avtomotive ligth housing;manual clamps;
URN: URN:SI:UM:
Vrsta dela (COBISS): Diplomsko delo
Komentar na gradivo: Univ. v Mariboru, Fak. za strojništvo
Strani: X, 68 f.
ID: 9129448