Benjamin Bizjan (Avtor), Brane Širok (Avtor), Jinpeng Chen (Avtor)

Povzetek

This paper presents an optical method and system for contactless measurement of the mass flow rate of melts by digital cameras. The proposed method is based on reconstruction of melt stream geometry and flow velocity calculation by cross correlation, and is very cost-effective due its modest hardware requirements. Using a laboratory test rig with a small inductive melting pot and reference mass flow rate measurement by weighing, the proposed method was demonstrated to have an excellent dynamic response (0.1 s order of magnitude) while producing deviations from the reference of about 5% in the steady-state flow regime. Similar results were obtained in an industrial stone wool production line for two repeated measurements. Our method was tested in a wide range of melt flow rates (0.05-1.2 kg/s) and did not require very fast cameras (120 frames per second would be sufficient for most industrial applications).

Ključne besede

optical measurements;mass flow rate;melt;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UL FS - Fakulteta za strojništvo
UDK: 535(045)
COBISS: 16345371 Povezava se bo odprla v novem oknu
ISSN: 1559-128X
Št. ogledov: 624
Št. prenosov: 286
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Slovenski jezik
Sekundarne ključne besede: optične meritve;masni pretok;taline;
Vrsta dela (COBISS): Članek v reviji
Konec prepovedi (OpenAIRE): 2019-05-20
Strani: str. 4202-4210
Letnik: ǂVol. ǂ57
Zvezek: ǂiss. ǂ15
Čas izdaje: May 2018
DOI: 10.1364/AO.57.004202
ID: 12855952
Priporočena dela:
, diplomska naloga visokošolskega strokovnega študija
, zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
, diplomska naloga [visokega] strokovnega študijskega programa