diplomsko delo
Uroš Oblak (Avtor), Mirko Kariž (Recenzent), Manja Kitek Kuzman (Mentor)

Povzetek

Namen diplomskega dela je oblikovati in konstruirati lesen stol z inovativnimi veznimi elementi. Narejen je bil pregled inovativnih vezi, ki se uporabljajo pri stolih. Idejna zasnova stola je bila modelirana s pomočjo programskega paketa SolidWorks po načelih ergonomije in antropometrije. Izdelan je bil prototip lesenega stola, ki smo ga nato preizkusili v Laboratoriju za preskušanje pohištva. S preizkušanjem po zahtevah standarda SIST EN 12520:2010 Pohištvo - Trdnost, trajnost in varnost - Zahteve za sedežno pohištvo za domačo uporabo smo želeli dokazati, da je stol primeren za domačo uporabo. Rezultati so pokazali, da je programska oprema SolidWorks primerno orodje za načrtovanje. Inovativni vezni element se je izkazal kot relativno enostaven za izdelavo. Med preizkušanjem smo odkrili težave z vgradnjo inovativnega veznega elementa, saj je popustilo lepilo na spoju les-kovina. Inovativni vezni elementi lahko v določenih primerih nadomestijo klasične mizarske vezi. Izračun mase v programu SolidWorks je pokazal, da so inovativni vezni elementi nekoliko lažji od klasičnih mizarskih vezi.

Ključne besede

konstruiranje;lesen stol;inovativni vezni elementi;SolidWorks;

Podatki

Jezik: Slovenski jezik
Leto izida:
Tipologija: 2.11 - Diplomsko delo
Organizacija: UL BF - Biotehniška fakulteta
Založnik: [U. Oblak]
UDK: 684.434
COBISS: 67688963 Povezava se bo odprla v novem oknu
Št. ogledov: 328
Št. prenosov: 33
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Angleški jezik
Sekundarni naslov: Construction of a wooden chair with thin metal connectors
Sekundarni povzetek: The aim of this BSc. thesis was to design and construct a wooden chair with innovative joint parts. We reviewed existing innovative joints used for chairs. The basic idea for the chair was designed using the SolidWorks platform, based on the principles of ergonomics and anthropometry. A prototype of chair was made and later tested at the laboratory for testing furniture. The test was conducted based on the standard SIST EN 12520:2010 Furniture - Strength, durability and safety - Requirements for domestic seating, and the results proved that the chair is suitable for domestic use. The results also showed that the SolidWorks platform is a suitable tool for designing and planning, and the innovative joints were easy to produce. However, during testing we faced problems with installation of the innovative joint parts because the glue between the wood and metal failed. The study shows that in some cases the innovative joint parts designed in this work could be used instead of classic wooden joints. The mass calculation in SolidWorks showed that the innovative joint parts are slightly lighter than classic wooden joints.
Sekundarne ključne besede: construction;wooden chair;innovative joint parts;SolidWorks;
Vrsta dela (COBISS): Diplomsko delo/naloga
Študijski program: 0
Komentar na gradivo: Univ. v Ljubljani, Biotehniška fak., Oddelek za lesarstvo
Strani: IX, 32 f., [15] f. pril.
ID: 13066524