Jaka Dugar (Avtor), Awais Ikram (Avtor), Franci Pušavec (Avtor)

Povzetek

Sintered zinc oxide (ZnO) ceramic is a fragile and difficult-to-cut material, so finishing operations demand handling cautious and accurate surface tolerances by polishing, grinding, or machining. The conventional machining methods based on grinding and lapping offer limited productivity and high scalability; therefore, their incapacity to prepare tight tolerances usually end up with uncontrolled edge chipping and rough surfaces in the final products. This study investigates microstructural features with surface roughness in a comparative mode for conventional milling and abrasive waterjet cutting (AWJ). Edge topography and roughness maps are presented in this study to weigh the benefits of AWJ cutting over the conventional material removal methods by altering the feed rates. The porosity analysis implies that the differences during the multi-channel processing of varistors, which tend to alter the microstructure, should in turn exhibit a different response during cutting. The surface roughness, edge contours, and porosity generation due to shear forces are interpreted with the help of 3D optical and electron microscopy. The results demonstrate that the surface microstructure can have a noteworthy impact on the machining/cutting characteristics and functionality, and in addition, mechanical properties of ZnO varistors can fluctuate with non-uniform microstructures.

Ključne besede

ZnO;varistorji;frezanje;rezanje z vodnim curkom;varistors;machining;milling;abrasive waterjet cutting;porosity;electron microscopy;edge radius (r) profilometry;surface roughness (Sa, S10Z);topography analysis;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UL FS - Fakulteta za strojništvo
UDK: 621.941(045)
COBISS: 80372739 Povezava se bo odprla v novem oknu
ISSN: 2076-3417
Št. ogledov: 177
Št. prenosov: 84
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Slovenski jezik
Sekundarne ključne besede: ZnO;varistorji;frezanje;rezanje z vodnim curkom;
Vrsta dela (COBISS): Članek v reviji
Strani: str. 1-15
Letnik: ǂVol. ǂ11
Zvezek: ǂiss. ǂ20
Čas izdaje: Oct. 2021
DOI: 10.3390/app11209410
ID: 13748135
Priporočena dela:
, ni podatka o podnaslovu
, diplomsko delo visokošolskega strokovnega študijskega programa
, diplomsko delo visokošolskega [strokovnega] študija
, diplomska naloga visokošolskega strokovnega študija
, diplomsko delo