Marko Jerman (Avtor), Henri Orbanić (Avtor), Joško Valentinčič (Avtor)

Povzetek

Ice abrasive water jet (IAWJ) technology uses ice particles instead of the mineral abrasives used in abrasive water jet (AWJ) technology. Since the thermal conditions are extremely important for the survival of the ice particles and their mechanical properties, the temperatures of the water jet and the adjacent air are analysed for different pressures and temperatures of the water upstream of the water nozzle and different nozzle orifice diameters. The temperature fields are calculated with a fully validated Computational Fluid Dynamic (CFD) model. The results show that the temperature of the jet core does not change significantly, but the adjacent air heats up considerably due to viscous heating; both are influenced by the water temperature and pressure upstream of the water nozzle. A low water temperature upstream of the water nozzle could significantly reduce the expected temperature of the ice particles exiting the cutting head. However, the use of a cold carrier gas such as nitrogen with a temperature of -196°C should not have a significant effect on the temperature of the ice particles inside the cutting head. It is recommended to optimise the geometry of the cutting head to reduce the travel time of the ice inside. If water cooling is not used, the ice particles should have a diameter of more than 0.5 mm. However, if cooling is used, particles as small as 0.3 mm in diameter can be used. The observed temperature conditions play a key role in the further development of IAWJ technology.

Ključne besede

water jet machining;CFD simulation;cold jet;IceJet technology;ice abrasive water jet;abbreviations;computational fluid dynamics;infrared;flash abrasive water jet;thermocouple;volume of fluid;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UL FS - Fakulteta za strojništvo
UDK: 621.924.9:532:519.62
COBISS: 98152707 Povezava se bo odprla v novem oknu
ISSN: 0020-7403
Št. ogledov: 37
Št. prenosov: 14
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Slovenski jezik
Sekundarne ključne besede: rezanje z abrazivnim vodnim curkom;numerične simulacije;hladen curek;ledeni abrazivni vodni curek;
Vrsta dela (COBISS): Članek v reviji
Strani: str. 1-41
Čas izdaje: Feb. 2022
DOI: 10.1016/j.ijmecsci.2022.107154
ID: 16317278
Priporočena dela:
, ni podatka o podnaslovu
, zaključna naloga Razvojno raziskovalnega programa I. stopnje Strojništvo
, magistrsko delo magistrskega študijskega programa II. stopnje Strojništvo
, diplomsko delo Visokošolskega strokovnega študijskega programa I. stopnje Strojništvo
, ni podatka o podnaslovu