Ivo Pahole (Avtor), Dejan Studenčnik (Avtor), Karl Gotlih (Avtor), Mirko Ficko (Avtor), Jože Balič (Avtor)

Povzetek

The quality of a tool's surface has a direct influence on the number of well-produced parts. For the machining of an active tool surface, two technological processes are used: electrical discharge machining and high-speed milling. These two processes are used when machining new tools and for the repairing of used forging tools. In both cases, the material has already been thermally treated, so it has to be used for hard milling. Practical experience shows that the milling strategy has a big influence on the durability of a forging tool. This paper shows the influence of the CNC machining direction during high-speed milling on the durability of the engraving within the forging tool. In some cases the correct milling strategy can increase the durability of the forging tool by about one third.

Ključne besede

orodja za kovanje;kakovost površine;visokohitrostno rezkanje;CNC-rezkanje;forging tools;surface quality;high speed cutting;CNC milling;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UM FS - Fakulteta za strojništvo
Založnik: = Association of Mechanical Engineers and Technicians of Slovenia et al.
UDK: 621.9
COBISS: 15657750 Povezava se bo odprla v novem oknu
ISSN: 0039-2480
Matična publikacija: Strojniški vestnik
Št. ogledov: 449
Št. prenosov: 27
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Angleški jezik
URN: URN:NBN:SI:doc-PW96EVMM
Vrsta dela (COBISS): Delo ni kategorizirano
Strani: str. 898-903
Letnik: Vol. 57
Zvezek: no. 12
Čas izdaje: dec. 2011
DOI: 10.5545/sv-jme.2010.078
ID: 1728332