Zoran Bergant (Avtor), Roman Šturm (Avtor), Damijan Zorko (Avtor), Borut Černe (Avtor)

Povzetek

This study focuses on investigating the fatigue and wear behaviour of carbon fibre reinforced polymer (CFRP) gears, which have shown promising potential as lightweight and high-performance alternatives to conventional gears. The gears were fabricated via an autoclave process using an 8-layer composite made of T300 plain weave carbon fabric and ET445 resin and were tested in pair with a 42CrMo4 steel pinion and under nominal tooth bending stress ranging from 60 to 150 MPa. In-situ temperature monitoring was performed, using an infrared camera, and wear rates were regularly assessed. The result of the wear test indicates adhesive wear and three-body abrasion wear mechanisms between the CFRP gears and the steel counterpart. A finite element analysis was performed to examine the in-mesh contact and root stress behaviour of both new and worn gears at various loads and a specified running time. The results point to a substantial divergence from ideal meshing and stress conditions as the wear level is increased. The fatigue results indicated that the CFRP gears exhibited superior performance compared to conventional plastic and composite short-fibrous polymer gears. The described composite gear material was additionally compared with two other composite configurations, including an autoclave-cured T700S plain weave prepreg with DT120 toughened resin and a vacuum-impregnated T300 spread plain weave carbon fabric with LG 900 UV resin. The study found that the use of the T700S-DT120 resulted in additional improvements.

Ključne besede

carbon fibre reinforced polymer;gears;fatigue;wear;finite element analysis;autoclave;vacuum infusion;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UL FS - Fakulteta za strojništvo
UDK: 621.83:620.178.3
COBISS: 148318211 Povezava se bo odprla v novem oknu
ISSN: 2073-4360
Št. ogledov: 1249
Št. prenosov: 245
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Slovenski jezik
Sekundarne ključne besede: kompoziti iz ogljikovih vlaken;zobniki;utrujanje;obraba;analiza po metodi končnih elementov;avtoklav;vakuumska infuzija;
Vrsta dela (COBISS): Članek v reviji
Strani: str. 1-24
Letnik: ǂVol. ǂ15
Zvezek: ǂiss. ǂ7
Čas izdaje: 2023
DOI: 10.3390/polym15071767
ID: 18561473