magistrsko delo
Klemen Plahuta (Avtor), Tone Lerher (Mentor), Aleksander Jordan (Komentor)

Povzetek

V magistrskem delu smo prikazali in preračunali verižni ter tračni transporter navpične in vodoravne izvedbe, ki sestavljajo novo transportno linijo za transport indonezijskega premoga. V izhodiščnem delu magistrskega dela je opisan posamezen transporter nove transportne linije. Preračuni odporov pri gibanju transporterjev in potrebne pogonske moči so izdelani analitično s pomočjo izrazov za preračun verižnega in tračnega transporterja. Določili smo potrebne moči posameznih transporterjev. Pri izračunu smo upoštevali podano zmogljivost, hitrost, nasipno gostoto premoga ter dolžino transporterja. Pri izdelavi numerične simulacije smo uporabili programski paket ANSYS Rocky in simulirali presipno mesto. Prikazali smo numerične rezultate masnega pretoka, obnašanje materiala, sile in napetosti nastale na tračnem transporterju.

Ključne besede

transport premoga;verižni transporter;tračni transporter;odpori pri gibanju in preračun pogonske moči;numerična simulacija DEM;magistrske naloge;

Podatki

Jezik: Slovenski jezik
Leto izida:
Tipologija: 2.09 - Magistrsko delo
Organizacija: UM FS - Fakulteta za strojništvo
Založnik: [K. Plahuta]
UDK: 621.867.016:622.647(043.2)
COBISS: 170621955 Povezava se bo odprla v novem oknu
Št. ogledov: 89
Št. prenosov: 0
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Angleški jezik
Sekundarni naslov: Calculation of the transport line for indonesian coal in premogovnik Velenje
Sekundarni povzetek: In the master thesis, we have demonstrated and calculated a chain and belt conveyors of vertical and horizontal design, which make up a new conveyor line for the transport of Indonesian coal. The initial part of the thesis describes the individual conveyors of the new transport line. The calculations of the conveyor motion resistance and the required drive power are made analytically using the expressions for the calculation of chain and belt conveyors. We have determined the required power of the individual conveyor. The calculation took into account the given capacity, speed, coal bulk density and conveyor length. We used the ANSYS Rocky software package to simulate the transfer chute. Numerical results of mass flow, material behaviour, forces and stresses on the conveyor belt are shown.
Sekundarne ključne besede: transportasion of coal;chain conveyor;belt conveyor;resistances to motion and calculation of power;numerical simulation DEM;
Vrsta dela (COBISS): Magistrsko delo/naloga
Konec prepovedi (OpenAIRE): 2026-09-19
Komentar na gradivo: Univ. v Mariboru, Fak. za strojništvo, Konstrukterstvo
Strani: 1 spletni vir (1 datoteka PDF (XIV, 89 f.))
ID: 19890707