Tadej Lešer (Avtor), Ivan Anžel (Avtor), Andreja Goršek (Avtor)

Povzetek

The production of powder materials from melts is usually done by atomisation. In our research two different frits were successfully produced using water atomisation technique. An overall assessment of the powders showed that the sizes of particles and their morphologies are determined mainly by the chemical compositions of the frits and atomisation parameters. The sizes of the particles depend on the viscosities of the frits, which is governed by the melt superheating during the experimental trials, orifice diameter and interactions between droplets and particles during additional stages after primary atomisation, which were controlled by water pressure. The morphologies of the particles depend on the relationships between the times of solidification and sphereoidisation and on the interactions between the particles.

Ključne besede

atomizacija vode;mikrostrukture;sferoidizacija;water atomisation;microstructure;spheroidisation;frits;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UM FKKT - Fakulteta za kemijo in kemijsko tehnologijo
UDK: 66
COBISS: 18353942 Povezava se bo odprla v novem oknu
ISSN: 0543-5846
Št. ogledov: 1919
Št. prenosov: 84
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Slovenski jezik
Sekundarne ključne besede: atomizacija vode;mikrostrukture;sferoidizacija;
URN: URN:SI:UM:
Vrsta dela (COBISS): Znanstveno delo
Strani: str. 485-488
Letnik: ǂVol. ǂ54
Zvezek: ǂno. ǂ3
Čas izdaje: 2015
ID: 9142057