Iskalni niz:
išči po
išči po
išči po
išči po
Vrsta gradiva:
Jezik:
Št. zadetkov: 5
Inteligentni sistem za korekcijo rezalnih parametrov pri frezanju gravur orodij
Marko Reibenschuh, Franc Čuš, Uroš Župerl
Doktorska disertacija
Oznake: inteligentni sistemi;rezalni parametri;frezanje gravur;nadzor sil;oblika odrezka;govorno vodenje;
Kvaliteta obdelane površine in stroški obdelave sta glavna faktorja, s katerima podjetje dosega konkurenčnost na svetovnem tržišču izdelave preoblikovalnih orodij. Z uporabo najnovejših materialov in modernih postopkovobdelave podjetja poskušajo doseči optimalno izkoriščenost strojev inorodij ter si ...
Leto: 2013 Vir: Fakulteta za strojništvo (UM FS)
Using LabVIEW software for development of new data acquisition software
Marko Reibenschuh, Franc Čuš, Uroš Župerl
Izvirni znanstveni članek
Oznake: monitoring;milling;data acquisition;LabVIEW;
LabVIEW enables programing and development of different interfaces for monitoring. Because of worldwide increasing demands for condition monitoring and demands to increase productivity, a new user interface for data acquisition is developed and applied to gather data and information during cutting. ...
Leto: 2012 Vir: Fakulteta za strojništvo (UM FS)
Turning of high quality aluminium alloys with minimum costs
Marko Reibenschuh, Franc Čuš, Uroš Župerl
Izvirni znanstveni članek
Oznake: aluminij;hladilno-mazalno sredstvo;struženje;stroški proizvodnje;
Turning is one of the most common metal cutting procedures used. To optimize such a cutting process, some adaptations must be made. Implementing tool wear conditioning and the use of dry cutting can significantly lower the production cost. This research focuses on the cost effectiveness of using dry ...
Leto: 2011 Vir: Fakulteta za strojništvo (UM FS)
Comparison of different optimization and process control procedures
Marko Reibenschuh, Franc Čuš, Uroš Župerl
Pregledni znanstveni članek
Oznake: optimization;milling;cutting parameters;LENS;
This paper includes a comparison of different optimization methods, used for optimizing the cutting conditions during milling. It includes also a part of using soft computer techniques in process control procedures. Milling is a cutting procedure dependent of a number of variables. These variables a ...
Leto: 2010 Vir: Fakulteta za strojništvo (UM FS)
Modelling and analysis of thermal and stress loads in train disc brakes - braking from 250 km/h to standstill
Marko Reibenschuh, Grega Oder, Franc Čuš, Iztok Potrč
Izvirni znanstveni članek
Oznake: zavorni disk;metoda končnih elementov;termična analiza;napetostna analiza;železniški transport;discs brake;temperature conditions;temeprature loads;locomotives;motor train set;
Thermal and stress analysis of disc brakes under specific loads (driving downhill and braking to a standstill) was calculated. The FEM (Finite Element Method) was used to carry out the analysis. The analysis dealt with centrifugal load for two cases of braking, braking to a standstill on a flat surf ...
Leto: 2009 Vir: Fakulteta za strojništvo (UM FS)
Št. zadetkov: 5
Ključne besede:
Leto izdaje:
Avtorji:
Repozitorij:
Tipologija:
Jezik: