Kambiz Mehrabi (Avtor), Mihael Brunčko (Avtor), Albert C. Kneissl (Avtor)

Povzetek

In order to get small-dimensioned shape memory alloys (SMAs) with good functional and mechanical properties, a rapid solidification technique was employed. This paper discusses the use of different melt-spinning procedures for the preparation of proper thin NiTi ribbons. Metallographic characterization of SMAs is an important way to evaluate material properties, therefore the effect of alloy composition and different conditions of melt-spinning process (crucible, melting time and temperature) on the various inclusions and microstructure of NiTi alloys was investigated. Specimens for metallographic studies were cut from the longitudinal cross sections of melt-spun ribbons. The microstructures and different phases were examined by optical, scanning and transmission electron microscopy and the influence of the processing methods on microstructures of ribbons will be discussed.

Ključne besede

Ni podatka o ključnih besedah

Podatki

Leto izida:
Tipologija: 1.01 - Izvirni znanstveni članek
Organizacija: UM FS - Fakulteta za strojništvo
UDK: 669:620.1/.2
COBISS: 16280854 Povezava se bo odprla v novem oknu
ISSN: 0032-678X
Št. ogledov: 626
Št. prenosov: 58
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni jezik: Angleški jezik
Sekundarni naslov: Untersuchung der Mikrostruktur schmelzgesponnener Bänder auf NiTi-Basis
Sekundarne ključne besede: shape memory alloys;rapid solidification;NiTi ribbons;
URN: URN:SI:UM:
Vrsta dela (COBISS): Delo ni kategorizirano
Strani: str. 544-555
Letnik: 49
Zvezek: 9
Čas izdaje: 2012
ID: 1439152