Bogdan Valentan (Avtor), Igor Drstvenšek (Avtor), Tomaž Brajlih (Avtor), Peter Sever (Avtor), Simon Brezovnik (Avtor), Jože Balič (Avtor)

Povzetek

Additive Fabrication technologies are well known from the last two decades. In that time Additive Fabrication technologies have evolved from strictly prototype part production into an option that can also be used to produce end-user parts. With development of Additive Fabrication machines capable of producing metal parts, a complete substitution of conventional metal casting technologies is possible. However, direct Additive Fabrication of metal parts is still not time/cost effective when producing large volume parts, and nowadays there is still lack of materials that can be used on those machines. This paper presents a method how a conventional sand casting process can be assisted by Additive Fabrication technologies. A sand mould pattern is produced by Selective Laser Sintering. Additive Fabrication is also used in direct manufacturing of cores.

Ključne besede

hitra izdelava prototipov;litje v pesek;sivo litje;tehnologija dodajanja materiala;gray cast iron;layered technologies;rapid prototyping;rapid manufacturing;sand casting;

Podatki

Jezik: Angleški jezik
Leto izida:
Tipologija: 1.04 - Strokovni članek
Organizacija: UM FS - Fakulteta za strojništvo
UDK: 621.74.041:669.131.6
COBISS: 14276886 Povezava se bo odprla v novem oknu
ISSN: 0562-1887
Št. ogledov: 1723
Št. prenosov: 18
Ocena: 0 (0 glasov)
Metapodatki: JSON JSON-RDF JSON-LD TURTLE N-TRIPLES XML RDFA MICRODATA DC-XML DC-RDF RDF

Ostali podatki

Sekundarni naslov: Tehnologije dodavanja materijala u metalurgiji - Studija slučaja produkcije ventila iz sivog lijeva
Sekundarne ključne besede: hitra izdelava prototipov;litje v pesek;sivo litje;tehnologija dodajanja materiala;
URN: URN:SI:UM:
Strani: str. 69-74
Letnik: ǂVol. ǂ52
Zvezek: ǂno. ǂ1
Čas izdaje: 2010
ID: 8718009